Category: Martys Garage

Extend Your Pedals To Accommodate Exhaust Pipe

So here’s a pretty common one, you put a monster expansion chamber pipe on your moped and now you can’t use your pedals since they don’t spin all the way around because there’s a big exhaust pipe in the way.

There’s a lot of different hacks and approaches to this problem, but this is the one I feel will work pretty much universally with any pipe on any moped.

Just make the pedal itself a little wider using… some pedals. Hack the end off an old pedal or two and weld them on to your existing pedal to extend it out. This way you’re not actually messing with the original pedal shaft, you can make use of the cotter pin holes and if you change pipes and it’s no longer necessary you can just grind off your extra pedal nubs.

Special thanks to Will Daloz of the SWOOPS for the idea!

The post Extend Your Pedals To Accommodate Exhaust Pipe appeared first on Marty’s Garage.

How to derestrict a Peugeot Simonini circuit pipe

This simonini circuit pipe can be a nice little blasty pipe but it takes a little bit of work. In the header of the pipe you’ll find a little restrictor that can easily be dremeled out. Once that’s out the pipe will be pretty usable, strong low and mid range.

That said there’s still some restriction in the pipe. I’m used to seeing silencers formed off the stinger by a perforated tube surrounded by fiberglass. This one uses a different design. It’s just two 2 short offset pipes. The stinger has an internal diameter of roughly 13mm and the pipes in the silencer are one 9mm. As the bike get’s into the higher rpms it’s unable to bleed off the exaust the bike is generating and you hit a wall.

I kept the design of the silencer the same on mine and I replaced the small 9mm pipe with some bigger ones that were closer to 17mm. I figured they still serve their purpose of quieting things down, but would no longer serve as a limiting factor.

Well that did the trick, it’s only slightly louder I still have decent low-end and the bike doesn’t hit a wall when accelerating anymore.

The post How to derestrict a Peugeot Simonini circuit pipe appeared first on Marty’s Garage.

1977 Racey Peugeot Kit Part 3

Well I think I’ve got my problems figured out with the Peugeot 50cc Racey Kit. On a whim I thought I’d throw a different pipe on and see how it’d perform. I had a spare RGD pipe that I was planning on using on a liquid cooled project I was saving for this winter.

With the new pipe on the kit really opened up. Low end kind of disappeared, but from mid to high the kit rips. I was doing mid 40s without much difficulty.

A clutch pulley would fix the low end problem, but I’m going to see if adding another star spring would help out.

The post 1977 Racey Peugeot Kit Part 3 appeared first on Marty’s Garage.